Cisco PIX 506 사용자 설명서 - 페이지 4

{카테고리_이름} Cisco PIX 506에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 506 8 페이지. Chapter 3
Cisco PIX 506에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지)

Connecting a Power Supply Module to the PIX 506/506E

Connect the RJ-45 connector to the PIX 506/506E and connect the other end to the serial port connector

Step 2

on your computer (see

Figure 3-5

Connect the inside network cable to the interface connector marked ETHERNET 0 or ETHERNET 1.

Step 3

Note

Connect the outside network cable to the remaining Ethernet port.

Step 4

Connecting a Power Supply Module to the PIX 506/506E

This section describes how to connect the power supply module to the PIX 506/506E. Use this

information in conjunction with the Regulatory Compliance and Safety Information document.

The PIX 506/506E uses an external AC to DC power supply. Power is supplied to the PIX 506/506E by

connecting the power supply to the back of the security appliance and connecting a separate AC power

cord to the power supply.

Cisco PIX Security Appliance Hardware Installation Guide

3-4

Figure

3-7).

PIX 506/506E Serial Console Cable

ACT

LINK

ACT

LINK

ETHE RNET 1

ETHE RNET 0

RJ-45 to

DB-9 or DB-25

serial cable

(null-modem)

The inside or outside network connections can be made to either interface port on the

PIX 506/506E.

POWE R

INPUT

USB

CON SOLE

Console

port (RJ-45)

Chapter 3

PIX 506/506E

Computer serial port

DB-9 or DB-25

78-15170-02