Cisco PIX 506 Kullanıcı Kılavuzu - Sayfa 4
Ağ Donanımı Cisco PIX 506 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco PIX 506 8 sayfaları. Chapter 3
Ayrıca Cisco PIX 506 için: Hızlı Başlangıç Kılavuzu (18 sayfalar)
Sayfayı YazdırConnecting a Power Supply Module to the PIX 506/506E
Connect the RJ-45 connector to the PIX 506/506E and connect the other end to the serial port connector
Step 2
on your computer (see
Figure 3-5
Connect the inside network cable to the interface connector marked ETHERNET 0 or ETHERNET 1.
Step 3
Note
Connect the outside network cable to the remaining Ethernet port.
Step 4
Connecting a Power Supply Module to the PIX 506/506E
This section describes how to connect the power supply module to the PIX 506/506E. Use this
information in conjunction with the Regulatory Compliance and Safety Information document.
The PIX 506/506E uses an external AC to DC power supply. Power is supplied to the PIX 506/506E by
connecting the power supply to the back of the security appliance and connecting a separate AC power
cord to the power supply.
Cisco PIX Security Appliance Hardware Installation Guide
3-4
Figure
3-7).
PIX 506/506E Serial Console Cable
ACT
LINK
ACT
LINK
ETHE RNET 1
ETHE RNET 0
RJ-45 to
DB-9 or DB-25
serial cable
(null-modem)
The inside or outside network connections can be made to either interface port on the
PIX 506/506E.
DC
POWE R
INPUT
USB
CON SOLE
Console
port (RJ-45)
Chapter 3
PIX 506/506E
Computer serial port
DB-9 or DB-25
78-15170-02