Cisco PIX 506E 사용자 설명서 - 페이지 8

{카테고리_이름} Cisco PIX 506E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 506E 8 페이지. Chapter 3
Cisco PIX 506E에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

Replacing a Lithium Battery

Figure 3-9

Warning

Danger of explosion exists if the lithium battery is incorrectly replaced. Replace only with the same

or equivalent type recommended by the manufacturer. Dispose of used batteries according to the

manufacturer's instructions.

To replace the lithium battery, perform the following steps:

Remove the chassis cover as described in the

Step 1

Use a flathead screwdriver to slide the battery out of the metal clip on the circuit board (see

Step 2

Place the used battery aside and replace it with a new battery. Install the new battery writing side up.

Step 3

The battery snaps into place as you slide it into the battery slot.

Step 4

Replace the chassis cover by lining up the cover tabs with the bottom panel tabs, and sliding the chassis

Step 5

cover back into the side and front panel slots on the chassis.

Replace the chassis cover as described in the

Step 6

Cisco PIX Security Appliance Hardware Installation Guide

3-8

PIX 506/506E Lithium Battery Location

Battery

"Removing the Chassis Cover" section on page

"Replacing the Chassis Cover" section on page

Chapter 3

PIX 506/506E

3-6.

Figure

3-9).

3-7.

78-15170-02