Cisco PIX 525 사용자 설명서 - 페이지 9

{카테고리_이름} Cisco PIX 525에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 525 30 페이지. Security appliance
Cisco PIX 525에 대해서도 마찬가지입니다: 데이터시트 (13 페이지)

Chapter 6

PIX 525

If you are using Stateful Failover, use one of the following types of connections, that is appropriate for

Step 5

your system, between the dedicated interfaces on the PIX security appliance units:

•

Caution

Do not turn the power on until the units are connected and the primary unit is configured completely.

Power the primary unit on first, then power on the secondary unit. Within a few seconds, the active unit

Step 6

automatically downloads its configuration to the standby unit.

If the primary unit fails, the secondary unit automatically becomes active.

Removing and Replacing the PIX 525 Chassis Cover

This section describes how to remove and replace the chassis cover from PIX 525. This section includes

the following topics:

•

Removing the Chassis Cover

Removing the PIX security appliance chassis cover does not affect your Cisco warranty. Upgrading the

Note

PIX security appliance does not require any special tools and does not create any radio frequency leak.

To remove the chassis cover, perform the following steps:

Read the Regulatory Compliance and Safety Information document.

Step 1

Power off the PIX 525 and disconnect site power.

Step 2

Note

Place the PIX 525 so that the front panel is facing you. If you place the PIX 525 on a table, ensure that

Step 3

you have clear access to all sides.

Remove the four screws on the chassis cover. (See

Step 4

78-15170-02

100BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch

1000BaseSX full duplex on a dedicated switch or dedicated VLAN of a switch

Removing the Chassis Cover, page 6-9

Replacing the Chassis Cover, page 6-11

The power switch is part of the power supply.

Removing and Replacing the PIX 525 Chassis Cover

Figure

6-8.)

Cisco PIX Security Appliance Hardware Installation Guide

6-9