Cisco PIX-515E 빠른 시작 매뉴얼 - 페이지 24

{카테고리_이름} Cisco PIX-515E에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX-515E 42 페이지. Security appliance
Cisco PIX-515E에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (42 페이지)

페이지 인쇄

To specify a local host or network to be allowed access to the IPSec tunnel, complete the following

steps:

1. Click IP Address.

2. Specify whether the interface is inside or outside by choosing one of the interfaces from the

drop-down menu.

3. Enter the IP address and mask.

4. Click Add.

5. Repeat steps 1 through step 5 for each host or network that you want to have access to the tunnel.

6. Click the Next button to continue.

Step 6: Specify Remote Hosts and Networks

Identify hosts and networks at the remote site to be allowed to use this IPSec tunnel to communicate

with the local hosts and networks you identified in Step 5. Add or remove hosts and networks

dynamically from the Selected panel by clicking on the >> or << buttons respectively. In the current

scenario, for PIX 1, the remote network is Network B (20.20.20.0), so traffic encrypted from this

network is permitted through the tunnel.