Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 42

{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)

페이지 인쇄

Reference Information

Step 2

Step 3

Step 4

Formatting a Flash Memory Card

The Flash memory (PCMCIA) card that shipped with your Cisco 7000 contains the Cisco IOS

software image. In some cases, you might need to insert a new Flash memory card and copy images

or backup conﬁguration ﬁles onto it. Before you can use a new Flash memory card, you must format

it.

Note

Warning

prevent the loss of important data on a Flash memory card, proceed carefully. If you wish to save the

data on a Flash memory card, upload the data to a server before you format the card.

Use the following procedure to format a new Flash memory card:

Step 1

Step 2

Note

the system counted the card's sectors backwards from 64 to 1 as it formatted them. For 16-MB Flash

memory cards, the system counts backwards from 128 to 1, and for 20-MB Flash memory cards, the

system counts backwards from 160 to 1.

The new Flash memory card is now formatted and ready to use.

Note

Products Command Reference Addendum (for Cisco IOS Release 10.3) and the Router Products

Conﬁguration Guide Addendum (for Cisco IOS Release 10.3).

42 7000 Series Route Switch Processor (RSP7000) Installation and Conﬁguration in the Cisco 7000 Series Routers

Insert the card into the appropriate slot until the card completely seats in the connector at

the back of the slot and the eject button pops out toward you (See Figure 9b.) Note that the

card does not insert all the way inside the RSP7000; a portion of the card will remain

outside the slot. Do not attempt to force the card past this point.

To eject a card, press the appropriate ejector button until the card is free of the connector at

the back of the slot. (See Figure 9c.)

Remove the card from the slot and place it in an antistatic bag to protect it.

The following procedure assumes you have already booted your router.

The following formatting procedure erases all information on the Flash memory card. To

Using the procedure in the section "Replacing a Flash Memory Card" on page 41 insert the

Flash memory card into slot 0. (If slot 0 is not available, use slot 1.)

To format the Flash memory card, use the format slot0: (or format slot1:) command as

follows. (Use only Intel Series 2+ Flash memory cards.)

Router# format slot0:

All sectors will be erased, proceed? [confirm]

Enter volume id (up to 30 characters): MyNewCard

Formatting sector 1

Format device slot0 completed

Router#

For this example, an 8-MB Flash memory card was used, and at the line "Formatting sector,"

For complete command descriptions and conﬁguration information, refer to the Router