Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 44

{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)

페이지 인쇄

Reference Information

Step 3

Note

"C" characters signify calculation of the checksum, which is a veriﬁcation that the ﬁle has been

correctly downloaded to the Flash memory card.

When the system reloads it will boot the image new.image from the Flash memory card in slot 0.

44 7000 Series Route Switch Processor (RSP7000) Installation and Conﬁguration in the Cisco 7000 Series Routers

To enable the router, copy the image new.image to the Flash memory card, make this image

in the Flash memory card (in slot 0) the default boot image, and reboot the router, use the

following series of commands:

Router> en

Password:

Router# copy tftp:new.image slot0:new.image

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

In the previous example, the exclamation points (!!!) appear as the ﬁle is downloaded and the

Router# config terminal

Router(config)# no boot system

Router(config)# boot system flash slot0:new.image

Router(config)# ^z

Router# copy running-config startup-config

Router# reload