Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 45
{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)
페이지 인쇄Copying Bootable Images Between Flash Memory Cards
As future releases of Cisco IOS images become available, you will receive these images either as a
netbooted file, a file on floppy disk, or a file on a Flash memory card.
The following scenario describes how to use a newly released image on a Flash memory card, in a
system that has an older image on a Flash memory card in slot 0 (and a default boot image in the
onboard Flash SIMM).
For this scenario, the filenames are as follows:
•
the new image on the new Flash memory card is image.new
•
the old image in the Flash memory card in slot 0 is image.old
•
the bootable image in onboard Flash memory is image.boot
You will copy the new image from the new Flash memory card onto the Flash memory card that
contains the old image.
Note
alongside the old image. If there is not enough available space, use the delete command to delete
files from the Flash memory card to make sufficient room for the new image; however, do not delete
the image.old file. Then use the squeeze command to remove these deleted files from the Flash
memory card. If, after you have deleted files and used the squeeze command, the two files cannot
coexist on the Flash memory card in slot 0, remove this card (place it in an anti-static bag and store
it in a safe place), then insert the new Flash memory card (with the file image.new) in slot 0. Proceed
to Step 5 and use the command boot system flash slot0:image.new to designate the file image.new
as the default boot image.
Step 1
Step 2
Step 3
Step 4
Note
7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers
The scenario assumes that the new image will fit on the Flash memory card in slot 0,
Boot the router. By default, the file image.boot will be used.
Enable the router as follows:
Router> en
Password:
Router#
Insert the new Flash memory card in slot 1.
Use the following command to copy the file image.new in slot 1, to the Flash memory card
in slot 0, only if there is enough memory space for the two images to coexist. If there is not
enough memory space, proceed to Step 5.
Router# copy slot1:image.new slot0:image.new
The previous command can also be entered as copy slot1:image.new slot0:.
Reference Information
45