Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 30

{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe

페이지 인쇄

Study the examples that follow to understand the procedure for various topologies.

Enter the topology configuration menu.

Step 1

Would you like to enter the Topology configuration menu? [no]: y

Enter your password if prompted.

–

Type y and press Enter.

The topology configuration dialog begins.

Step 2

Specify the connection mode.

To define inline connection mode, press Enter.

–

To define receive-only connection mode, type 2 and press Enter.

–

Enter Connection mode:

1- inline

2- receive-only

Enter your choice [1]:

Specify the On-failure link behavior.

Step 3

To specify Bypass, press Enter.

–

To specify Cutoff, type

–

Enter On-failure behavior:

1- bypass

2- cutoff

Enter your choice [1]:

Specify the admin status of the SCE 1000 after abnormal boot.

Step 4

To specify Not-Operational status after abnormal boot, press Enter.

–

To specify Operational status after abnormal boot, type

–

Enter admin status of the SCe after abnormal boot:

1- Operational

2- Not-Operational

Enter your choice [1]:

Examples

The following examples present the procedure for configuring the topology-related parameters for various topologies. Refer the

Setup Command Parameters, page 14 for a summary of appropriate values for the parameters for each topology.

• Example 1:, page 30

• Example 2:, page 31

• Example 3:, page 31

Example 1:

Following is a sample topology configuration for a topology using an external switch.

All other parameter values are automatically assigned by the system as follows:

• Link bypass mode on-failure — Bypass

• Admin status of the SCE after abnormal boot — Operational

Would you like to enter the Topology configuration menu? [no]: y

Enter Connection mode:

1- inline

2- receive-only

Enter your choice [1]: 2

and press Enter.