Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 34

{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe

페이지 인쇄

Example 3:

Following is an example of a configuration that was aborted, although no errors were detected.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]:

Apply and Save this configuration? [yes/no]: n

The changes you have just entered would be discarded, are you sure? [yes/no]:y

Setup procedure aborted, no configuration changes made.

Connect the Management Interface

Figure 15

Cabling the Management Port

MN G 1

MN G 2

CO NS OL

LIN K/

10/1 00/

ACT IVE

LIN K/

100 0

10/1 00/

ACT IVE

100 0

By default, the management port is configured to auto-negotiation enabled.

Note

The SCE 1000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.

Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the

Step 1

SCE 1000.

Step 2

Connect the other end of the Ethernet cable into your management network.

The Link LED on the SCE 1000 management port should light up.

Test connectivity. From the host that you intend to use for remote management, ping to the SCE 1000 by typing ping

Step 3

and the SCE 1000 IP address, and pressing Enter (see the example, below).

This verifies that an active connection exists between the specified station and the management port.

Example:

The following example displays a typical ping response where the target IP address is 10.1.1.201.

C:\>ping 10.1.1.201

pinging 10.1.1.201...

PING 10.1.1.201: 56 data bytes

64 bytes from host (10.1.1.201): icmp_seq=0. time=0. ms

64 bytes from host (10.1.1.201): icmp_seq=1. time=0. ms

64 bytes from host (10.1.1.201): icmp_seq=2. time=0. ms

64 bytes from host (10.1.1.201): icmp_seq=3. time=0. ms

----10.1.1.201 PING Statistics----

4 packets transmitted, 4 packets received, 0% packet loss

round-trip (ms) min/avg/max = 0/0/0

PW R A

PW R B

STA TU S

BY PAS S

C is co S

LIN K RX

AU X

4 xG B E

LIN K RX

GB E-1

SU B

LIN E

NE T

GB E-2

SU B LIN

E/C AS CA

DE NE T

C E 2 0 0 0

Se rie s

LIN K RX