Cisco SCE8000 10 GBE 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Cisco SCE8000 10 GBE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE8000 10 GBE 25 페이지. 10 gbe power supply

Figure 10

Cabling the 10 GBE Interface

S C E 80 00

-S IP

The Link LED should be green.

Completing the Installation

This module explains how to verify link connectivity and how to install a Cisco service control application.

• The 10 GBE Link LED should be green. This indicates that an active connection exists.

• The 10 GBE RX and TX LEDs (if flashing green) indicate that traffic is being received or transmitted by the SCE 8000

platform, respectively.

In an inline topology, the RX and TX LEDs indicate that packets are being received and transmitted by the

Note

SCE 8000 platform.

• In optical splitter topologies, the RX LEDs are the sole indicators. The TX LEDs do not blink, because the TX is not

connected to the port in this topology.

Viewing 10-Gigabit Ethernet Port Status

At the Cisco SCE> prompt, type show interface TenGigabitEthernet 3/ baynumber /0.

Step 1

This displays the port link status.

The following example shows how to display a system response.

Cisco SCE8000>show interface TenGigabitEthernet 3/1/0

Actual Status:

Link is on

Bandwidth: 10000000Kbps

Burst-size: 500000bytes

SP A -1 X1

0G E- L- V2

SP A -1 X1

0G E- L- V2