Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub 매뉴얼 - 페이지 13
{카테고리_이름} Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub 18 페이지. 4-port pocket usb kvm switch with usb 2.0 hub
Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)
페이지 인쇄
4. Switching the USB KVM Switch
USB KVM Switch supports 3 methods to switch between computers:
Push button, Hot Keys and OSD. Due to refresh of the video and
re-synchronization of the mouse and keyboard signal, it will take 1-3
seconds configure time after each switching. This is the normal operation
that ensures the proper synchronization is established.
Note:
The drivers for most USB devices (Mass Storage device, CCD Cameras,
Scanners, Card Reader, Printers, e.g.) are required to be shut down or
follow the "Safely Remove" command provided in Windows before you
disconnect the device, or else the system might be hanged. When you
switch computers with the Port Selection Switch, it is the equivalent of
disconnecting the device. Therefore, if you have peripheral devices (other
than a second keyboard and mouse) connected to these ports, you must
be sure to shut down or safely remove the USB driver for them before
switching computers.
1. Manual Switch by pushbutton:
You can switch to any other available active USB host connection by
simply push the appropriate switch button on USB KVM Switch. The LED
will be lit to indicate which port is currently selected.
2. Two Steps Hot Key Switch by keyboard:
You can switch to any available active USB host connection by using the
three steps Hot Key directly, instead of manually select by pushbutton. To
send commands to USB KVM Switch,
( Step1 ). Then you can press [1] to [4] (Step 2) to switch between ports.
(Support PS/2 Keyboard only)
*After invoking the Hot Key function with the
key in the corresponding active key (Step 2) within 3 seconds for
each key press.
(The Scroll LED will start blinking and wait for the Step 2 hotkey, after
pressing any key or over 3 seconds, the keyboard LED will back to the
original status.)
must be pressed twice
- 13 -
13
you must