Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub Manual - Página 13
Procurar online ou descarregar pdf Manual para Interruptor Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub. Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub 18 páginas. 4-port pocket usb kvm switch with usb 2.0 hub
Também para Digitus 4-Port Desktop USB KVM Switch with USB 2.0 Hub: Manual (18 páginas)
Imprimir página
4. Switching the USB KVM Switch
USB KVM Switch supports 3 methods to switch between computers:
Push button, Hot Keys and OSD. Due to refresh of the video and
re-synchronization of the mouse and keyboard signal, it will take 1-3
seconds configure time after each switching. This is the normal operation
that ensures the proper synchronization is established.
Note:
The drivers for most USB devices (Mass Storage device, CCD Cameras,
Scanners, Card Reader, Printers, e.g.) are required to be shut down or
follow the "Safely Remove" command provided in Windows before you
disconnect the device, or else the system might be hanged. When you
switch computers with the Port Selection Switch, it is the equivalent of
disconnecting the device. Therefore, if you have peripheral devices (other
than a second keyboard and mouse) connected to these ports, you must
be sure to shut down or safely remove the USB driver for them before
switching computers.
1. Manual Switch by pushbutton:
You can switch to any other available active USB host connection by
simply push the appropriate switch button on USB KVM Switch. The LED
will be lit to indicate which port is currently selected.
2. Two Steps Hot Key Switch by keyboard:
You can switch to any available active USB host connection by using the
three steps Hot Key directly, instead of manually select by pushbutton. To
send commands to USB KVM Switch,
( Step1 ). Then you can press [1] to [4] (Step 2) to switch between ports.
(Support PS/2 Keyboard only)
*After invoking the Hot Key function with the
key in the corresponding active key (Step 2) within 3 seconds for
each key press.
(The Scroll LED will start blinking and wait for the Step 2 hotkey, after
pressing any key or over 3 seconds, the keyboard LED will back to the
original status.)
must be pressed twice
- 13 -
13
you must