Cisco TelePresence MCU 4500 Series 시작하기 - 페이지 6

{카테고리_이름} Cisco TelePresence MCU 4500 Series에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MCU 4500 Series 18 페이지. Multipoint control units
Cisco TelePresence MCU 4500 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (15 페이지)

페이지 인쇄

Connecting the MCU

Before you start

IMPORTANT

information at

Step one: Connect power

Connect the power connector on the rear of the unit to the power supply using the

supplied power cable. (There is no On/Off switch.)

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a

hub, to minimize interference from other devices on the network). The Ethernet

port is a 10/100/1000 Mbps auto-sensing connection.

Only connect to Ethernet Port B if you need to connect the MCU to a

second subnet.

Do not connect Ethernet Port A and Ethernet Port B to the same subnet.

: Before installing the MCU, you must read the safety

http://www.cisco.com/go/telepresence/safety

Connecting the MCU