Cisco TelePresence MCU 4500 Series Getting Started - Page 6
Browse online or download pdf Getting Started for Network Hardware Cisco TelePresence MCU 4500 Series. Cisco TelePresence MCU 4500 Series 18 pages. Multipoint control units
Also for Cisco TelePresence MCU 4500 Series: Getting Started Manual (15 pages)
Print Page
Connecting the MCU
Before you start
IMPORTANT
information at
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the
supplied power cable. (There is no On/Off switch.)
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection.
Only connect to Ethernet Port B if you need to connect the MCU to a
i
second subnet.
Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
!
: Before installing the MCU, you must read the safety
http://www.cisco.com/go/telepresence/safety
Connecting the MCU
.
6