Cisco UBR7246VXR 하드웨어 설치 - 페이지 9

{카테고리_이름} Cisco UBR7246VXR에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UBR7246VXR 25 페이지. Universal broadband router
Cisco UBR7246VXR에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지), 사용자 설명서 (7 페이지), 설치 매뉴얼 (28 페이지)

페이지 인쇄

Attach the Rack-Mount Brackets to the Rear of the Chassis

To install the rack-mount brackets on the chassis for a rear rack-mount configuration, complete the following steps:

Step 1

Locate the threaded holes in the rear sides of the chassis.

Step 2

Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See Figure 4.

Figure 4

Installing the Rack-Mount Brackets on the Rear of the Chassis

Rack-mount

bracket

Note

There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR. You may use either set

of four holes to align the bracket to the threaded holes in the sides of the chassis.

Step 3

Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.

Use a number 2 Phillips screwdriver to tighten the screws.

Step 4

Repeat Step 1 through Step 3 for the other rack-mount bracket.

Step 5

See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.

Attach the Rack-Mount Brackets to the Front of the Chassis

To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the following steps.

Step 1

Locate the threaded holes in the front sides of the chassis.

Step 2

If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to the threaded

holes in the right side of the chassis as shown in Figure 5

If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the threaded holes

in the right side of the chassis as shown in Figure 6.

Note

There are eight holes in each of the rack-mount brackets. You may use either set of four holes to align the bracket to

the threaded holes in the sides of the chassis.

Step 3

Thread the four M4 x 6-mm Phillips flathead screws through the bracket and into the side of the chassis. Use a

number 2 Phillips screwdriver to tighten the screws.

Step 4

Repeat Step 1 through Step 3 for the other rack-mount bracket.

Rack-mount

bracket