Cisco UBR7246VXR Instalação de hardware - Página 9
Procurar online ou descarregar pdf Instalação de hardware para Hardware de rede Cisco UBR7246VXR. Cisco UBR7246VXR 25 páginas. Universal broadband router
Também para Cisco UBR7246VXR: Manual de início rápido (27 páginas), Manual do utilizador (7 páginas), Manual de instalação (28 páginas)
Imprimir página
Attach the Rack-Mount Brackets to the Rear of the Chassis
To install the rack-mount brackets on the chassis for a rear rack-mount configuration, complete the following steps:
Step 1
Locate the threaded holes in the rear sides of the chassis.
Step 2
Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See Figure 4.
Figure 4
Installing the Rack-Mount Brackets on the Rear of the Chassis
Rack-mount
bracket
Note
There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR. You may use either set
of four holes to align the bracket to the threaded holes in the sides of the chassis.
Step 3
Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Step 5
See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.
Attach the Rack-Mount Brackets to the Front of the Chassis
To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the following steps.
Step 1
Locate the threaded holes in the front sides of the chassis.
Step 2
If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to the threaded
holes in the right side of the chassis as shown in Figure 5
If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the threaded holes
in the right side of the chassis as shown in Figure 6.
Note
There are eight holes in each of the rack-mount brackets. You may use either set of four holes to align the bracket to
the threaded holes in the sides of the chassis.
Step 3
Thread the four M4 x 6-mm Phillips flathead screws through the bracket and into the side of the chassis. Use a
number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Rack-mount
bracket
9