Cisco UCS B200 M3 설치 및 서비스 참고 사항 - 페이지 6

{카테고리_이름} Cisco UCS B200 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 28 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 설치 및 서비스 참고 사항 (36 페이지), 설치 및 서비스 참고 사항 (37 페이지), 매뉴얼 (8 페이지), 업그레이드 매뉴얼 (21 페이지)

Procedure

Step 1

Place the drive ejector into the open position by pushing the release button.

Figure 4: Installing a Hard Drive in a Blade Server

Step 2

Gently slide the drive into the opening in the blade server until it seats into place.

Step 3

Push the drive ejector into the closed position.

You can use Cisco UCS Manager to format and configure RAID services. For details, see the Configuration Guide for

the version of Cisco UCS Manager that you are using. The configuration guides are available at the following URL:

http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html

If you need to move a RAID cluster, see the

Blade Server Removal and Installation

Before performing any internal operations on this blade server, you must remove it from the chassis.

Caution

To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the carrier edges only.

Powering Off a Blade Server Using the Power Button

Note

The front panel power button is disabled by default to ensure that servers are decommissioned through the UCS Manager

software before shutdown. If you prefer to shut down the server locally with the button, you can enable front power-button

control in UCS Manager.

Tip

You can also shut down servers remotely using Cisco UCS Manager. For details, see the Configuration Guide for the version

of Cisco UCS Manager that you are using. The configuration guides are available at the following URL:

http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html

Cisco UCS Manager Troubleshooting Reference

Guide.