Cisco VIP4-50= 설치 및 구성 매뉴얼 - 페이지 38

{카테고리_이름} Cisco VIP4-50=에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VIP4-50= 44 페이지. Fourth generation versatile interface processor

VIP4 Maintenance Procedures

Figure 11

Use the following procedure to remove the slot divider from a VIP4:

Step 1

Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.

Remove the VIP4 from the router. (See the

Step 2

Place the removed VIP4 on an antistatic mat or foam pad.

Step 3

Remove any installed port adapters or blank port adapters from the port adapter slots on the VIP4. To

Step 4

do this, use a number 1 Phillips screwdriver to remove the screw located at the rear of each port adapter

slot.

•

To locate this screw on single-width port adapters, see the first panel of

•

To locate this screw on dual-width port adapters, see the first panel of

Use a number 1 Phillips screwdriver to remove the four slot divider screws that secure the slot divider

Step 5

to the VIP4 motherboard. (See

Step 6

Remove the slot divider and store it (and the screws) in a location where you can retrieve it for use later.

Note

With the slot divider removed, see

dual-width port adapter.

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

Location of VIP4 Slot Divider and Screws

Screw holes for septum

Figure

If you need to reinstall the port adapter slot divider, place the slot divider in position on the VIP4

and secure it with the four Phillips screws.

"Removing a VIP4" section on page

11.)

Figure

12, which describes the steps required to install or remove a

18.)

Figure

10.

Figure

12.

OL-3673-01