Cisco 2500 Series 설치 매뉴얼 - 페이지 7
{카테고리_이름} Cisco 2500 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2500 Series 12 페이지. Wireless controller
Cisco 2500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 배포 매뉴얼 (23 페이지), 구성 매뉴얼 (50 페이지), 시작하기 매뉴얼 (47 페이지)
페이지 인쇄
To fit the two sections together, it may be necessary to work them together at one end and
Caution
then the other, working back and forth; however, use care to prevent bending the chassis edges. (To
see translated versions of this warning, refer to the Regulatory Compliance and Safety Information
document that accompanied the router.)
Figure 8
Replacing the Chassis Cover
A
Rear
When the two sections fit together snugly, turn the chassis so that the bottom is facing up,
Step 3
with the front panel toward you.
Replace the cover screw. (See Figure 8.)
Step 4
Remove the protective cover from the back of the power requirements label.
Step 5
Carefully place the label directly over the silk screened power requirements information
Step 6
on the rear panel of the system.
Remove the protective cover from the back of the system designation label.
Step 7
Carefully place the label directly over the silk screened system designation information
Step 8
on the rear panel of the system.
Step 9
Reinstall the chassis on the wall, rack, desktop, or table.
Step 10
Replace all cables.
Step 11
Remove your ESD-preventive wrist strap.
Note
Ensure that the System OK LED is not covered by the system designation label.
This completes the procedure for installing AC and DC power supplies. If you have questions or
need assistance, see the section "Obtaining Service and Support."
C
Top section
Bottom section
Left end
toward you
Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers
B
Front
Replacing the Cover
7