Cisco 2500 Series Manual de instalación - Página 7

Navegue en línea o descargue pdf Manual de instalación para Servidor Cisco 2500 Series. Cisco 2500 Series 12 páginas. Wireless controller
También para Cisco 2500 Series: Manual de configuración (19 páginas), Manual de implantación (23 páginas), Manual de configuración (50 páginas), Manual de introducción (47 páginas)

To ﬁt the two sections together, it may be necessary to work them together at one end and

Caution

then the other, working back and forth; however, use care to prevent bending the chassis edges. (To

see translated versions of this warning, refer to the Regulatory Compliance and Safety Information

document that accompanied the router.)

Figure 8

Replacing the Chassis Cover

Rear

When the two sections ﬁt together snugly, turn the chassis so that the bottom is facing up,

Step 3

with the front panel toward you.

Replace the cover screw. (See Figure 8.)

Step 4

Remove the protective cover from the back of the power requirements label.

Step 5

Carefully place the label directly over the silk screened power requirements information

Step 6

on the rear panel of the system.

Remove the protective cover from the back of the system designation label.

Step 7

Carefully place the label directly over the silk screened system designation information

Step 8

on the rear panel of the system.

Step 9

Reinstall the chassis on the wall, rack, desktop, or table.

Step 10

Replace all cables.

Step 11

Remove your ESD-preventive wrist strap.

Note

Ensure that the System OK LED is not covered by the system designation label.

This completes the procedure for installing AC and DC power supplies. If you have questions or

need assistance, see the section "Obtaining Service and Support."

Top section

Bottom section

Left end

toward you

Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers

Front

Replacing the Cover