Cisco 2500 Series 시작하기 매뉴얼 - 페이지 18

{카테고리_이름} Cisco 2500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2500 Series 47 페이지. Wireless controller
Cisco 2500 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 구성 매뉴얼 (19 페이지), 배포 매뉴얼 (23 페이지), 구성 매뉴얼 (50 페이지)

페이지 인쇄

Installing the Controller

Figure 10

#10-32 pan-head screws or #12-24 slotted head screws

After the controller is mounted in the rack, perform the following tasks to complete the installation:

Step 3

•

Step 4

For configuration instructions about using the CLI setup program, see the

and Power-On Self Test" section on page

Connecting the Controller Console Port

Do not connect a Power over Ethernet (PoE) cable to the console port. Doing so will damage the

Caution

controller.

Before you can configure the 2504 controller for basic operations, you need to connect it to a PC that

uses a VT-100 terminal emulator (such as HyperTerminal, ProComm, Minicom, or Tip). To connect the

PC to the controller console port, follow these steps:

Plug the RJ-45 connector on a null-modem serial cable into the controller console port and the other end

Step 1

of the cable into the serial port of the PC.

Cisco 2500 Series Wireless Controller Getting Started Guide

Mounting the Controller in a 19-Inch Rack

Connecting the Controller Console Port

Securing the Power Adapter Cable

Connecting to the Network

20.

"Running the Bootup Script