Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 15
{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)
페이지 인쇄
Install the Hardware
Connect DC-Input Power Supply
ly
move
DC-input power su
with the terminal b
cover removed
Power leads
DC
attached to
FA N O
terminal block
OK
OK
(+) Positive
(–) Negative
( ) Ground
Conduit
bracket
Ca
inst
s
Warning
The system power switch on the
power supply should be off.
Step 1
Use a screwdriver to loosen and remove
the terminal block cover screws.
Step 2
Lift and remove the terminal block cover.
Step 3
Route the DC-input power cable from the
power source through the conduit bracket
on the power supply. Allow sufficient
slack in the cable.
Step 4
Attach and tighten the conduit to the
conduit bracket.
Note
The proper wiring sequence is ground to
ground, positive to positive (line to L), negative to
negative (neutral to N). The ground wire should
always be connected first and disconnected last.
13