Cisco 7513 Series Manuel de démarrage rapide - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 7513 Series. Cisco 7513 Series 44 pages. Chassis replacement
Également pour Cisco 7513 Series : Manuel d'instructions de remplacement (26 pages), Fiche technique (11 pages), Manuel (30 pages), Maintien (20 pages), Manuel d'instructions de remplacement (19 pages), Manuel d'instructions de remplacement (22 pages)

Install the Hardware

Connect DC-Input Power Supply

move

DC-input power su

with the terminal b

cover removed

Power leads

attached to

FA N O

terminal block

(+) Positive

(–) Negative

( ) Ground

Conduit

bracket

inst

Warning

The system power switch on the

power supply should be off.

Step 1

Use a screwdriver to loosen and remove

the terminal block cover screws.

Step 2

Lift and remove the terminal block cover.

Step 3

Route the DC-input power cable from the

power source through the conduit bracket

on the power supply. Allow sufﬁcient

slack in the cable.

Step 4

Attach and tighten the conduit to the

conduit bracket.

Note

The proper wiring sequence is ground to

ground, positive to positive (line to L), negative to

negative (neutral to N). The ground wire should

always be connected ﬁrst and disconnected last.