Cisco 7513 Series 매뉴얼 - 페이지 25

{카테고리_이름} Cisco 7513 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 30 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

When the system starts up and operates successfully, the replacement procedure is complete, and

you can resume normal operation.

If the system still fails to start up or operate properly, or if you isolate the cause of the problem to a

failed component, contact a service representative for further assistance.

Note

parts. If the old chassis is still mounted in a rack, follow the steps in the "Removing the Existing

Chassis from the Rack" section on page 13" to remove it. Place spare interface processors or

interface processor ﬁllers in the chassis slots, and move the chassis to the appropriate location for

storage or shipment.

Verifying the Installation Using show Command Descriptions and Examples

This section describes the various show commands that you can use to display system status and

conﬁguration. If you installed the interface processors in the same slot locations that they occupied

in the old chassis, the interfaces should retain the same conﬁguration. If you installed the interface

processors in different slot locations, the system will recognize the interfaces, but you will have to

use the conﬁgure command to reconﬁgure and enable them.

You can check the version of the default ROM image either by removing the board and checking the

ROM labels or by conﬁguring the interface or system software to boot from ROM, restarting the

system, and using these same commands to check the running version.

Note

software that is being used.

Verifying the Installation Using show Command Descriptions and Examples

After you verify a successful installation, gather the old chassis and any remaining spares and

The following examples may differ based on the router model and version of Cisco IOS

Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions