Cisco 7513 Series 교체 지침 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 7513 Series에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 19 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Replacing a Power Supply

Follow these steps to replace the power supply:

Step 1

Step 2

Step 3

Note

cable at the power source.

This completes the power supply replacement procedure.

Checking the System

To complete the installation, perform a ﬁnal check of all connections, then restart the system. This

procedure is not for new systems; perform this procedure only if you have already connected the

network interfaces and performed the ﬁrst-time startup procedures discussed in the Cisco 7513

Hardware Installation and Maintenance publication and the Router Products Getting Started Guide.

Follow these steps to restart the system and verify that the system restarts successfully:

Step 1

Step 2

Step 3

Step 4

14 Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions

To replace a power supply, hold it as shown in Figure 7 and slide it into the power supply

bay. Push the supply all the way into the chassis until the sides are ﬂush against the chassis

frame.

Use a large slotted screwdriver to tighten the captive screw that secures the power supply

to the chassis frame. (See Figure 6.)

Reconnect the power supply cables between the power supplies.

For DC-input power supplies, refer to the conﬁguration note "1200-Watt DC-Input Power

Supply Replacement Instructions" (Document Number 78-1899-01) that shipped with the

Cisco 7513 chassis equipped with DC-input power supplies.

For AC-input power supplies, refer to the conﬁguration note "1200-Watt AC-Input Power

Supply Replacement Instructions" (Document Number 78-1900-01) that shipped with the

Cisco 7513 chassis equipped with AC-input power supplies.

After the AC power cable or DC power cable leads are reconnected, reconnect the power

Check the following components to make sure they are secure:

•

Processor modules are fully inserted in the slots and all captive screws are tightened.

•

Interface cable connections are secured.

•

Power supplies are fully inserted in the bays, and the captive screws are tightened.

•

Power supply cables are fully connected to the power supplies and the power source,

and secured with appropriate strain relief.

Ensure that a console terminal is connected to the RSP2 console port and turned on, or that

you have a remote login to the router from another device through a Telnet session. (You

will need to check the startup banner and displays to ensure that the system restarts properly

and that all the interfaces reinitialize in the proper state.)

When you have checked all of the connection points, turn on the supply in the power A bay

by turning its power switch clockwise one-quarter turn. The OK LED on the power supply

and the power A LED on the front of the chassis should go on.

After the power supply in bay A is on, turn the second power supply on in bay B, if one is

present for redundant power. The OK LED on each power supply and the power A (and B)

LEDs on the front of the chassis should go on.