Cisco 7513 Series 교체 지침 매뉴얼 - 페이지 15
{카테고리_이름} Cisco 7513 Series에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 19 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (22 페이지)
페이지 인쇄
If you try to turn on a power supply and the switch resists, the power supply probably is not
Note
fully inserted into the bay. Turn the power switch fully counterclockwise (to O), pull the power
supply out of the bay about two inches, then push the power supply firmly back into the slot. Do not
slam the supply into the slot—doing so can damage the connectors on the supply and the backplane.
Tighten the captive installation screw before turning on the switch.
Listen for the system blower. You should hear it start operating immediately.
Step 5
On the console terminal, verify that the console displays the system banner and that the
Step 6
system and all interfaces initialize successfully. Following is an example of this display.
(display text omitted)
GS Software (RSP-K), Version 10.3(571)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Wed 10-May-95 25:12
RSP2 (Risc 4600) processor with 16384K bytes of memory.
(display text omitted)
If the power supplies do not start up, or if the system or any interfaces do not initialize properly, refer
to the Cisco 7513 Hardware Installation and Maintenance publication for additional information
and installation troubleshooting procedures. If necessary, contact a service representative. (See the
following section "Cisco Information Online.")
Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions
Checking the System
15