Cisco 7513 Series 교체 지침 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 7513 Series에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 22 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지)

페이지 인쇄
Cisco 7513 Series 교체 지침 매뉴얼
Removing the Existing Chassis from the Rack
Before removing the existing chassis from the rack, you must shut down the system power and
disconnect the power cable and all interface cables. To help avoid problems when you install the new
chassis, label all interface cables with their slot/port address and mark the positions of the chassis
ears (with tape, chalk, or a marker) so that you can install the new chassis in the same position.
Two chassis ears hold the chassis in the rack (see Figure 3), but do not bear the weight of the chassis.
The ears are secured to the chassis sides and to the rack posts. The chassis is supported by the two
rack brackets.
Figure 3
POW ER
A
We recommend that two people perform this procedure: one person should support the chassis while
the other person removes the screws that secure the ears to the rack.
Follow these steps to remove the existing chassis from the rack:
Step 1
Step 2
Chassis, Rack Brackets, and Ears
Turn OFF the system power and disconnect the power cable and all interface cables from
the chassis.
Use a screwdriver to loosen and remove each of the four screws (two on each side) that
secure the chassis ears to the rack rails.
M4 x 10-mm long
Phillips flat-head
screws (to attach
ears to chassis)
Bracket (2)
POW ER
B
Cisco 7513 Chassis Replacement Instructions
Replacing the Chassis
9