Cisco 7513 Series Instrukcja wymiany - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Serwer Cisco 7513 Series. Cisco 7513 Series 22 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Instrukcja wymiany (26 strony), Arkusz danych (11 strony), Podręcznik (30 strony), Utrzymanie (20 strony), Instrukcja wymiany (19 strony)

Removing the Existing Chassis from the Rack

Before removing the existing chassis from the rack, you must shut down the system power and

disconnect the power cable and all interface cables. To help avoid problems when you install the new

chassis, label all interface cables with their slot/port address and mark the positions of the chassis

ears (with tape, chalk, or a marker) so that you can install the new chassis in the same position.

Two chassis ears hold the chassis in the rack (see Figure 3), but do not bear the weight of the chassis.

The ears are secured to the chassis sides and to the rack posts. The chassis is supported by the two

rack brackets.

Figure 3

POW ER

We recommend that two people perform this procedure: one person should support the chassis while

the other person removes the screws that secure the ears to the rack.

Follow these steps to remove the existing chassis from the rack:

Step 1

Step 2

Chassis, Rack Brackets, and Ears

Turn OFF the system power and disconnect the power cable and all interface cables from

the chassis.

Use a screwdriver to loosen and remove each of the four screws (two on each side) that

secure the chassis ears to the rack rails.

M4 x 10-mm long

Phillips flat-head

screws (to attach

ears to chassis)

Bracket (2)

POW ER

Cisco 7513 Chassis Replacement Instructions

Replacing the Chassis