Cisco 7513 Series Instrukcja wymiany - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Serwer Cisco 7513 Series. Cisco 7513 Series 22 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Instrukcja wymiany (26 strony), Arkusz danych (11 strony), Podręcznik (30 strony), Utrzymanie (20 strony), Instrukcja wymiany (19 strony)

Replacing the Chassis

Replacing a Rack-Mounted Chassis

This section describes how to replace a chassis that is installed in an equipment rack. The order in

which you remove the existing system, install the new chassis, and replace the components will vary

depending upon the space available in the rack and in the work area.

Some rack conﬁgurations, such as an enclosed rack or a rack with a power strip that limits access,

prohibit the normal installation sequence of ﬁrst installing the chassis in the rack and then installing

the cable-management brackets before installing the processor modules. In these situations, you can

move all the components into the new chassis before installing it in the rack, but ensure that you

follow the safety guidelines for lifting and working with electrical equipment that are provided in

the section "Safety Guidelines" beginning on page 3.

If there is sufﬁcient space available in the same rack (or an adjacent rack) and you have a rack-mount

kit available, you can install the new (replacement) chassis before you remove the existing system.

You can minimize downtime and avoid having to disconnect network interface cables by leaving the

existing system operating while you install the empty replacement chassis in the rack. Also, an

empty chassis is signiﬁcantly lighter and easier to handle than one that is fully conﬁgured. Just

ensure that both chassis, when installed, will be close enough to avoid straining the interface cables

connected to the interface processors.

If you must remove the existing system to make room for the replacement chassis, or if you need the

existing rack-mounting hardware to mount the new chassis, you will have to disconnect all network

interface cables before removing the existing system from the rack. You can leave the system

components in the old chassis until after you install the new, empty chassis in the rack.

Assess your rack and lab conﬁguration and the equipment you have available, then choose the

appropriate replacement procedure from the following:

•

8 Cisco 7513 Chassis Replacement Instructions

If you have a spare rack-mount kit available and are able to install the new, empty chassis before

you shut down and remove the existing one, follow the installation instructions provided with the

rack mount kit, Cisco 7513 Rack-Mount Kit Installation Instructions (Document Number

78-2023-xx). After you install the new chassis in the rack and install the cable-management

brackets, proceed to the section "Moving Processor Modules from the Old Chassis to the New

Chassis," on page 13, to move the components. (After you complete the replacement and check

the installation, you will be directed to the following section, "Removing the Existing Chassis

from the Rack," to remove the empty chassis.)

If you must remove the existing chassis before you can install the new one, proceed to the

following section, "Removing the Existing Chassis from the Rack."