Cisco APIC M4 설치 및 서비스 매뉴얼 - 페이지 41

{카테고리_이름} Cisco APIC M4에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco APIC M4 46 페이지.

페이지 인쇄

Server Specifications

Sound power level

Measure A-weighted per ISO7779 LwAd (Bels)

Operation at 73°F (23°C)

Sound pressure level

Measure A-weighted per ISO7779 LpAm (dBA)

Operation at 73°F (23°C)

Cisco Virtual Interface Card (VIC) Considerations

This section describes VIC card support and special considerations for this server.

Note

Table 6: VIC Support and Considerations in This Server

VIC

Cisco VIC 1455

APIC-PCIE-C25Q-04

Note

5.8

If you use the Cisco Card NIC mode, you must also make a VIC Slot setting that matches where your

VIC is installed. The options are Riser1, Riser2, and Flex-LOM. See

Settings, on page 30

for more information about NIC modes.

How Many

Slots That

Supported in

Support VICs

Server

2 PCIe

PCIe 1

PCIe 2

This VIC supports 10/25-Gigabit with the following restrictions:

• All ports must have the same speed.

• Port 1 and port 2 is one pair, corresponding to eth2-1 on APIC. Port 3 and port 4 is another pair,

corresponding to eth2-2 on APIC. Only one connection is allowed for each pair. For example, you

can connect one cable to either port 1 or port 2, and you can connect another one cable to either

port 3 or port 4. Do not connect two cables on any pair.

• APIC-PCIE-IQ10GC or UCSC-PCIE-IQ10GC should always be installed in PCIE slot 1 for APIC

M4/L4.

• APIC-PCIE-IQ10GC or UCSC-PCIE-IQ10GC can use any ports or any pair of ports to connect to

a leaf node.

• From Release 4.2(5) the UCSC-PCIE-IQ10GC Intel X710 Quad Port 10GBase-T network interface

card is supported for 10GBast-T connectivity to Cisco ACI leaf nodes.

Cisco Virtual Interface Card (VIC) Considerations

Primary Slot For

Cisco UCS Manager

Cisco Card NIC

Integration

Mode

PCIe 1

Cisco APIC M4/L4 Server Installation and Service Guide

NIC Mode and NIC Redundancy

Minimum Cisco

IMC Firmware

4.0(1)