Cisco AS5300 - Universal Access Server 부록

{카테고리_이름} Cisco AS5300 - Universal Access Server에 대한 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AS5300 - Universal Access Server 10 페이지. Access server
Cisco AS5300 - Universal Access Server에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (25 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (21 페이지)

Cisco AS5300 - Universal Access Server 부록

Cabling Specifications

This appendix provides the following cabling and pinout information for the Cisco AS5300
universal access server:

Console and Auxiliary Port Cables and Pinouts

Ethernet Port Pinouts
T1/PRI and E1/PRI Card Port Pinouts
T1/PRI and E1/PRI Card Cable Assemblies and Pinouts
Note
appendix are not connected.
Console and Auxiliary Port Cables and Pinouts
The access server arrives with a console and auxiliary cable kit, which contains the cable and
adapters you need to connect a console (an ASCII terminal or PC running terminal emulation
software) or modem to your access server. The console and auxiliary cable kit includes:
RJ-45-to-RJ-45 rollover cable. (See the next section, "Identifying a Rollover Cable," for more
information.)
RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL).
RJ-45-to-DB-25 male DCE adapter (labeled MODEM).
For console connections, proceed to the section "Console Port Cables and Pinouts" later in this
appendix; for modem connections, proceed to the section "Auxiliary Port Signals and Pinouts" later
in this appendix.

Identifying a Rollover Cable

You can identify a rollover cable by comparing the two modular ends of the cable. Holding the cables
side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug
should be the same color as the wire connected to the pin on the outside of the right plug. (See
Figure D-1.) If your cable was purchased from Cisco Systems, pin 1 will be white on one connector,
and pin 8 will be white on the other connector (a rollover cable reverses pins 1 and 8, 2 and 7, 3 and
6, and 4 and 5).
This appendix specifies pinouts only for the pins used. Pins not listed in the tables in this
A P P E N D I X
Cabling Specifications D-1
D