Cisco AS5300 - Universal Access Server Bijlage
Blader online of download pdf Bijlage voor {categorie_naam} Cisco AS5300 - Universal Access Server. Cisco AS5300 - Universal Access Server 10 pagina's. Access server
Ook voor Cisco AS5300 - Universal Access Server: Snelstarthandleiding (25 pagina's), Configuratiehandleiding (46 pagina's), Handmatig (21 pagina's)
Pagina afdrukken
Cabling Specifications
This appendix provides the following cabling and pinout information for the Cisco AS5300
universal access server:
•
Console and Auxiliary Port Cables and Pinouts
•
Ethernet Port Pinouts
•
T1/PRI and E1/PRI Card Port Pinouts
•
T1/PRI and E1/PRI Card Cable Assemblies and Pinouts
Note
appendix are not connected.
Console and Auxiliary Port Cables and Pinouts
The access server arrives with a console and auxiliary cable kit, which contains the cable and
adapters you need to connect a console (an ASCII terminal or PC running terminal emulation
software) or modem to your access server. The console and auxiliary cable kit includes:
•
RJ-45-to-RJ-45 rollover cable. (See the next section, "Identifying a Rollover Cable," for more
information.)
•
RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
•
RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL).
•
RJ-45-to-DB-25 male DCE adapter (labeled MODEM).
For console connections, proceed to the section "Console Port Cables and Pinouts" later in this
appendix; for modem connections, proceed to the section "Auxiliary Port Signals and Pinouts" later
in this appendix.
Identifying a Rollover Cable
You can identify a rollover cable by comparing the two modular ends of the cable. Holding the cables
side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug
should be the same color as the wire connected to the pin on the outside of the right plug. (See
Figure D-1.) If your cable was purchased from Cisco Systems, pin 1 will be white on one connector,
and pin 8 will be white on the other connector (a rollover cable reverses pins 1 and 8, 2 and 7, 3 and
6, and 4 and 5).
This appendix specifies pinouts only for the pins used. Pins not listed in the tables in this
A P P E N D I X
Cabling Specifications D-1
D