Cisco C880 M4 펌웨어 업데이트 매뉴얼

{카테고리_이름} Cisco C880 M4에 대한 펌웨어 업데이트 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C880 M4 5 페이지. System event log collection
Cisco C880 M4에 대해서도 마찬가지입니다: 서비스 보충 설명서 (27 페이지), 하드웨어 설치 매뉴얼 (23 페이지), 운영 매뉴얼 (48 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Cisco C880 M4 Server Firmware Update Guide

First Published: August 24, 2016

Introduction

This document describes how to update the firmware on a Cisco C880 M4 server. There are two update

procedures:

•

The procedures are identical except for the state of the system when the procedure is initiated.

Both update procedures instruct you to perform a Unified Firmware Update from the Management Board

(MMB) web UI. The Unified Firmware Update updates the following firmware:

• BIOS firmware

• BMC firmware

• MMB firmware

The BIOS and BMC firmware data are stored in ROM devices on each system board (SB): 0, 1, 2, and 3. The

MMB firmware data are stored in a ROM device on the MMB.

The version of the BIOS firmware on each system board should be the same, and the version of the BMC

firmware on each system board should be the same. When a system board is replaced with a spare system

board, the version of the new system board may not be the same as the version of the firmware on other system

boards. When this situation occurs, perform a Unified Firmware Update to make all firmware versions equal.

Procedure Summary

We recommend performing the

Step 1

Shut down the OS and power off the system (but do not disconnect the power cord).

Step 2

Stop issuing IPMI commands from Cisco UCS Director to the ManageMent Board (MMB) of the C880 M4 Server.

Step 3

Perform the Unified Firmware Update from the MMB web UI to apply the firmware binary so that it starts running.

Step 4

Set the new BMC username and password as described in

Step 5

Resume issuing IPMI commands from Cisco UCS Director to the C880 M4 Server.

Offline Firmware Update

Procedure, which should be initiated when the server is powered off.

Online Firmware Update

Procedure, which should be initiated when the server is powered on (in Boot

state).

Offline Firmware Update Procedure

as a part of this overall workflow:

Changing a Username and Password

Cisco C880 M4 Server Firmware Update Guide