Cisco Firepower 2130 시작하기 - 페이지 17

{카테고리_이름} Cisco Firepower 2130에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 2130 42 페이지. Rack-mount and ground the chassis
Cisco Firepower 2130에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 배포 매뉴얼 (8 페이지), 설치 및 유지 관리 (26 페이지)

페이지 인쇄

Getting Started

Cabling for the Firepower 4100

Perform the initial Firepower Threat Defense configuration on the logical device Management interface. You

can later enable management from any data interface. The Firepower Threat Defense device requires internet

access for licensing and updates, and the default behavior is to route management traffic to the gateway IP

address you specified when you deployed the device. If you want to route management traffic over the

backplane to the data interfaces instead, you can configure that setting in the FDM later.

Cable the following interfaces for initial chassis setup, continued monitoring, and logical device use.

• Console port—Connect your management computer to the console port to perform initial setup of the

• Chassis Management port—Connect the chassis management port to your management network for

• FTD Logical device Management interface—You can choose any interface on the chassis for this purpose

• Data interfaces—Connect the data interfaces to your logical device data networks. You can configure

Note

chassis. The Firepower 4100 includes an RS-232–to–RJ-45 serial console cable. You might need to use

a third party serial-to-USB cable to make the connection.

configuration and ongoing chassis management.

other than the chassis management port, which is reserved for FXOS management.

physical interfaces, EtherChannels, and breakout ports to divide up high-capacity interfaces.

For High Availability, use a Data interface for the failover/state link.

All interfaces other than the console port require SFP/SFP+/QSFP transceivers. See the

guide

for supported transceivers.

Cabling for the Firepower 4100

hardware installation

Getting Started