Cisco ONS 15454 설치 - 페이지 16

{카테고리_이름} Cisco ONS 15454에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15454 32 페이지. Four-shelf and zero-shelf bay assembly
Cisco ONS 15454에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (22 페이지), 설치 (32 페이지), 포장 풀기 및 설치 (42 페이지), 포장 풀기 및 설치 (40 페이지)

페이지 인쇄
Cisco ONS 15454 설치
NTP-A120 Install an External Wire-Wrap Panel to the AEP
Required/As Needed
Onsite/Remote
Security Level
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Complete the
Step 1
AIC or AIC-I card and are not using an AEP.
Complete the
Step 2
wires are necessary to provision external timing.
Complete the
Step 3
(or the LAN port on the TCC2/TCC2P) are necessary to create an external LAN connection.
Complete the
Step 4
the EIA/TIA-232 port on the TCC2/TCC2P) are required to access TL1 using the craft interface.
Caution
Complete one of the following:
Step 5
•
•
•
Stop. You have completed this procedure.
NTP-A120 Install an External Wire-Wrap Panel to the AEP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Position the lower cover over the AEP. Make sure that the AEP AMP Champ connectors protrude
Step 1
through the cutouts in the lower cover
Cisco ONS 15454 Procedure Guide, R5.0
1-16
As needed
Onsite
None
"DLP-A19 Install Alarm Wires on the Backplane" task on page 17-22
"DLP-A20 Install Timing Wires on the Backplane" task on page 17-25
"DLP-A21 Install LAN Wires on the Backplane" task on page 17-26
"DLP-A22 Install the TL1 Craft Interface" task on page 17-27
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf
assembly.
If you installed an AEP, continue with the
AEP" procedure on page
1-16.
If you did not install an AEP and you plan to install electrical cards, continue with the
Install the Electrical Card Cables on the Backplane" procedure on page
If you did not install an AEP and do not plan to install electrical cards, continue with the
Install the Rear Cover" procedure on page
This procedure connects an external wire-wrap panel to the AEP to provide
the physical alarm contacts for the AEP.
External wire-wrap panel
NTP-A119 Install the Alarm Expansion Panel, page 1-12
As needed
Onsite
None
Chapter 1
"NTP-A120 Install an External Wire-Wrap Panel to the
1-23.
(Figure
1-5).
Install the Shelf and Backplane Cable
if you are using an
as needed. Timing
as needed. LAN wires
as needed. Craft wires (or
"NTP-A9
1-22.
"NTP-A11
March 2005