Cisco ONS 15454 SDH 절차 매뉴얼 - 페이지 2

{카테고리_이름} Cisco ONS 15454 SDH에 대한 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15454 SDH 22 페이지. Install cards and fiber-optic cable

NTP- D15 Install the Common Control Cards

NTP-D15 Install the Common Control Cards

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

Always use the supplied ESD wristband when working with a powered ONS 15454 SDH. Plug the

Caution

wristband cable into the ESD jack located on the lower-right outside to edge of the shelf assembly.

If protective clips are installed on the backplane connectors of the cards, remove the clips before

Note

installing the cards.

If you install a card incorrectly, the FAIL LED flashes continuously.

Note

If you plan to install XC-VXL-2.5G cards, review

Step 1

compatibility. If you plan to install XC-VXL-10G or XC-VXC-10G cards, review

to determine card/slot compatibility.

Complete the

Step 2

Figure 2-1

Cisco ONS 15454 SDH Procedure Guide, R8.5

2-2

This procedure describes how to install the common control cards.

Redundant TCC2/TCC2P cards

Redundant XC-VXL-2.5G, XC-VXL-10G, or XC-VXC-10G cross-connect

cards

AIC-I card (optional)

NTP-D13 Perform the Shelf Installation Acceptance Test, page 1-19

Required

Onsite

Provisioning or higher

"DLP-D332 Install the TCC2/TCC2P Cards" task on page

shows card installation.

Chapter 2 Install Cards and Fiber-Optic Cable

Table 2-1 on page 2-3

to determine card/slot

20-22.

Table 2-2 on page 2-5

78-18118-01