Cisco ONS 15454 SDH Procedure Manual - Page 2
Browse online or download pdf Procedure Manual for Server Cisco ONS 15454 SDH. Cisco ONS 15454 SDH 22 pages. Install cards and fiber-optic cable
Print Page
NTP- D15 Install the Common Control Cards
NTP-D15 Install the Common Control Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Always use the supplied ESD wristband when working with a powered ONS 15454 SDH. Plug the
Caution
wristband cable into the ESD jack located on the lower-right outside to edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
If you plan to install XC-VXL-2.5G cards, review
Step 1
compatibility. If you plan to install XC-VXL-10G or XC-VXC-10G cards, review
to determine card/slot compatibility.
Complete the
Step 2
Figure 2-1
Cisco ONS 15454 SDH Procedure Guide, R8.5
2-2
This procedure describes how to install the common control cards.
Redundant TCC2/TCC2P cards
Redundant XC-VXL-2.5G, XC-VXL-10G, or XC-VXC-10G cross-connect
cards
AIC-I card (optional)
NTP-D13 Perform the Shelf Installation Acceptance Test, page 1-19
Required
Onsite
Provisioning or higher
"DLP-D332 Install the TCC2/TCC2P Cards" task on page
shows card installation.
Chapter 2 Install Cards and Fiber-Optic Cable
Table 2-1 on page 2-3
to determine card/slot
20-22.
Table 2-2 on page 2-5
78-18118-01