B2 Audio M 12 소유자 매뉴얼 - 페이지 4
{카테고리_이름} B2 Audio M 12에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B2 Audio M 12 6 페이지. High performance amplifier
4-1. MOUNTING PREPARATION
For safety purposes, install the amplifier in a dry and well ventilated location and
make sure no cables or other harness of the car is interfaced with the mounting location or
4-2. +12V, GND, REM CONNECTION
12V ( POWER CONNECTION )
B2
Before mounting
any accidentIal damage to the amplifier or the audio system.
B2
series are designed to use 0 AWG power and Ground connection.
Connect the power cables to power terminal labeled as + 12V.
For the use of external fuses, then connect one end of
the fuse holder to the power cable and the other end of the fuse holder to positive battery
within 20 cm of the same cable.
This fuse location will protect the system and the vehicle against the possibility of a short circuit
in the power cable. Be sure to use fuses and a fuse holder adequate for the application.
GND ( GROUND CONNECTION )
Locate a secure grounding connection as close to the amplifier as possible.
Make sure the location is clean and provides a direct electrical connection to the frame
of the vehicle. Connect one end of a short piece of the same size cable as the power cable
to the grounding point. Run one end of the cable to the grounding point.
Run the other end of the cable to the mounting location.
Connect the ground cable to the screw terminal labeled as GND.
REM ( REMOTE CONNECTION )
Run a remote turn on cable from the switched + 12V source.
This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna
Connect the remote turn on cable to the power terminal labeled as REM.
trigger cable.
+12V, GND, REM CONNECTION DIAGRAM
Headunit
Ground
Ground
amplifiers, disconnect the negative ( - ) wire from the battery to protect
Remote turn on
4