Cisco S695F 매뉴얼 - 페이지 13
{카테고리_이름} Cisco S695F에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S695F 24 페이지. Web security appliance
Cisco S695F에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (18 페이지), 하드웨어 설치 매뉴얼 (50 페이지)
페이지 인쇄
Overview
The following figure shows the rear panel of the WSA S695F. See
description of the LEDs.
Figure 12: S695F Rear Panel
1
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
3
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
5
1050-W AC power supply (PSU 1)
7
Threaded holes for dual-hole grounding lug
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
9
Management interface 1 (MGMT 1)
Restricted to management use only
11
USB 3.0 Type A (USB 2)
Rear Panel LEDs, on page 14
2
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
4
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
You can connect P1 and P2 to an L4
Note
switch, WCCP router, or network
switch.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
6
1050-W AC power supply (PSU 2)
8
Management interface 2 (MGMT 2)
Not supported
10
USB 3.0 Type A (USB 1)
12
Data interface (DATA 1)
Rear Panel
for a
Overview
13