Cisco S695F Manual - Page 13
Browse online or download pdf Manual for Server Cisco S695F. Cisco S695F 24 pages. Web security appliance
Also for Cisco S695F: Getting Started Manual (18 pages), Hardware Installation Manual (50 pages)
Print Page
Overview
The following figure shows the rear panel of the WSA S695F. See
description of the LEDs.
Figure 12: S695F Rear Panel
1
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
3
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
5
1050-W AC power supply (PSU 1)
7
Threaded holes for dual-hole grounding lug
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
9
Management interface 1 (MGMT 1)
Restricted to management use only
11
USB 3.0 Type A (USB 2)
Rear Panel LEDs, on page 14
2
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
4
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
You can connect P1 and P2 to an L4
Note
switch, WCCP router, or network
switch.
1/10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+ transceivers.
6
1050-W AC power supply (PSU 2)
8
Management interface 2 (MGMT 2)
Not supported
10
USB 3.0 Type A (USB 1)
12
Data interface (DATA 1)
Rear Panel
for a
Overview
13