Cisco SCE8000 GBE 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Cisco SCE8000 GBE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE8000 GBE 25 페이지. 10gbe platform
Cisco SCE8000 GBE에 대해서도 마찬가지입니다: 구성 매뉴얼 (18 페이지), 제거 및 교체 절차 (36 페이지), 설치 (21 페이지)

페이지 인쇄

Because the power requirement of the SCE8000 will not exceed 1350 W, it is not necessary to connect two pairs of input

Note

wires to each power supply. If you want to connect two pairs of input wires, both pairs of input wires for one 2700 W

DC-input power supply must come from the same battery system (A feed); and both pairs of input wires for the other

power supply must come from another battery system (B feed).

For multiple DC input power supplies, each DC input must be protected by a dedicated circuit breaker or fuse. The

Note

circuit breaker or fuse should be sized according to the power supply input rating and local or national electrical code

requirements.

Power supply ground is required. Install the PWR-2700-DC/4 power supply ground as described in this procedure.

Step 1

The system ground connection with the PWR-2700-DC/4 power supply in a Cisco SCE 8000 is provided by the

Note

PWR-2700-DC/4 power supply ground. Additionally, you can connect a system (earth) ground.

You must always connect the PWR-2700-DC/4 power supply ground.

Note

You must always connect the PWR-2700-DC/4 power supply ground for both power supplies.

Note

If you intend to use an additional system (earth ground), ensure that the system ground connection is made. For

ground connection installation instructions, see the

Remove the plastic bag attached to the front panel and put aside. This bag contains two plastic terminal block barriers,

Step 2

two cable ties, and two cable holder covers.

Verify that power is off to the DC circuit connected to the power supply you are installing. Grasp both power supply

Step 3

handles

(Figure

5.) Slide the power supply into the power supply bay. Make sure that the power supply is fully seated

in the bay.

Figure 5

Handling a DC-Input Power Supply

"Connecting the Chassis Ground" section on page