Cisco SNS-3495 series 설치 매뉴얼 - 페이지 26

{카테고리_이름} Cisco SNS-3495 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS-3495 series 36 페이지. Sns-3400 series
Cisco SNS-3495 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (19 페이지), 문제 해결 매뉴얼 (8 페이지)

페이지 인쇄

Install the Side Rails

Note

The mounting pegs that protrude through the rack-post holes are designed to fit round or square holes, or

smaller #10-32 round holes when the mounting peg is compressed. If your rack has #10-32 rack-post holes,

align the mounting pegs with the holes and then compress the spring-loaded pegs to expose the #10-32 inner

peg.

c) Expand the length-adjustment bracket until the rear mounting pegs protrude through the desired holes in the rear rack

post.

Use your finger to hold the rear securing latch open when you insert the rear mounting pegs to their holes. When you

release the latch, it wraps around the rack post and secures the slide-rail assembly.

Figure 5: Attaching a Slide Rail Assembly

Front-left rack post

Front mounting pegs

Slide-rail assembly

d) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are

level and at the same height with each other.

e) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Step 3

Insert the server into the slide rails:

Note

The inner rails are pre-attached to the sides of the server at the factory. You can order replacement inner rails

if these are damaged or lost (Cisco PID UCSC-RAIL1-I).

a) Align the inner rails that are pre-attached to the server sides with the front ends of the empty slide rails.

b) Push the server into the slide rails until it stops at the internal stops.

Cisco SNS-3400 Series Appliance Hardware Installation Guide

Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

Length-adjustment bracket

Rear mounting pegs

Rear securing latch