Cisco SNS-3495 series Instrukcja instalacji - Strona 26
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco SNS-3495 series. Cisco SNS-3495 series 36 stron. Sns-3400 series
Również dla Cisco SNS-3495 series: Instrukcja instalacji (19 strony), Instrukcja rozwiązywania problemów (8 strony)
Drukuj stronę
Install the Side Rails
Note
The mounting pegs that protrude through the rack-post holes are designed to fit round or square holes, or
smaller #10-32 round holes when the mounting peg is compressed. If your rack has #10-32 rack-post holes,
align the mounting pegs with the holes and then compress the spring-loaded pegs to expose the #10-32 inner
peg.
c) Expand the length-adjustment bracket until the rear mounting pegs protrude through the desired holes in the rear rack
post.
Use your finger to hold the rear securing latch open when you insert the rear mounting pegs to their holes. When you
release the latch, it wraps around the rack post and secures the slide-rail assembly.
Figure 5: Attaching a Slide Rail Assembly
1
Front-left rack post
2
Front mounting pegs
3
Slide-rail assembly
d) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are
level and at the same height with each other.
e) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.
Step 3
Insert the server into the slide rails:
Note
The inner rails are pre-attached to the sides of the server at the factory. You can order replacement inner rails
if these are damaged or lost (Cisco PID UCSC-RAIL1-I).
a) Align the inner rails that are pre-attached to the server sides with the front ends of the empty slide rails.
b) Push the server into the slide rails until it stops at the internal stops.
Cisco SNS-3400 Series Appliance Hardware Installation Guide
22
Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
4
Length-adjustment bracket
5
Rear mounting pegs
6
Rear securing latch