Cisco SNS-3515 series 매뉴얼 - 페이지 19

{카테고리_이름} Cisco SNS-3515 series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS-3515 series 41 페이지. Sns 3500 series
Cisco SNS-3515 series에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (41 페이지), 문제 해결 매뉴얼 (8 페이지)

페이지 인쇄
Cisco SNS-3515 series 매뉴얼
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
What to Do Next

Install the Cable Management Arm (Optional)

The CMA is reversible left to right. To reverse the CMA, see Reversing the Cable Management Arm
Note
(Optional) before installation.
Step 1
With the server pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the server onto the
end of the stationary slide rail that is attached to the rack post (see the following figure). Slide the tab over the end of
the rail until it clicks and locks.
Step 2
Slide the CMA tab that is closest to the server over the end of the inner rail that is attached to the server (see the following
figure). Slide the tab over the end of the rail until it clicks and locks.
Step 3
Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your
rack (see the following figure).
Step 4
Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached
to the rack post (see the following figure). Slide the tab over the end of the rail until it clicks and locks.
Step 5
Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.
Figure 8: Attach the Cable Management Arm to the Rear of the Slide Rails
Install the Cisco SNS 3515 or 3595 Appliance in a Rack
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
19