Cisco SNS-3515 series Руководство - Страница 19

Просмотреть онлайн или скачать pdf Руководство для Сервер Cisco SNS-3515 series. Cisco SNS-3515 series 41 страница. Sns 3500 series
Также для Cisco SNS-3515 series: Руководство по установке оборудования (41 страниц), Руководство по устранению неполадок (8 страниц)

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances

What to Do Next

Install the Cable Management Arm (Optional)

The CMA is reversible left to right. To reverse the CMA, see Reversing the Cable Management Arm

Note

(Optional) before installation.

Step 1

With the server pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the server onto the

end of the stationary slide rail that is attached to the rack post (see the following figure). Slide the tab over the end of

the rail until it clicks and locks.

Step 2

Slide the CMA tab that is closest to the server over the end of the inner rail that is attached to the server (see the following

figure). Slide the tab over the end of the rail until it clicks and locks.

Step 3

Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your

rack (see the following figure).

Step 4

Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached

to the rack post (see the following figure). Slide the tab over the end of the rail until it clicks and locks.

Step 5

Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.

Figure 8: Attach the Cable Management Arm to the Rear of the Slide Rails

Install the Cisco SNS 3515 or 3595 Appliance in a Rack

Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1