Epson ES-300C 제품 지원 게시판 - 페이지 4

{카테고리_이름} Epson ES-300C에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-300C 13 페이지. Laser & non-impact printer error codes
Epson ES-300C에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 매뉴얼 (8 페이지), 보충 설명서 (15 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (25 페이지)

페이지 인쇄

[E] PAPER OUT SET STD XXX

There is no paper in the standard paper cassette.

display prompts you to load the correct paper size into the standard paper

cassette.

[E] PAPER SIZE ERROR

The paper size you selected with SelecType (or the default size if

have not selected a size) does not match the paper loaded in the selected

paper cassette.

[S] PRINTING

The printer has received data and is printing.

[S] PRINT STOP X/X

The printer stops printing during a multi-copy print operation.

[S] RAM Check X.X MB

The printer is checking RAM (X.X = capacity).

[S] READY

The printer is ready to print.

[E] REINSERT CARD

If this message appears on the display, you

card or cartridge while the FEED light was still lit or while the printer

was on line.

EPL-7000 cont.

[E] REMOVE CARD

You may have inserted a font card or cartridge while the printer was on line

or while the FEED light was on.

[E] RESELECT TRAY

The optional lower paper cassette is not installed and the INPUT option is

set to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified

with LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

[E] SAVE MEMORY OVERFLOW

If this message appears when you are trying to save a macro with the SAVE

MACRO option in SelecType Level 1, the printer does not have enough

memory to save any additional macros

[E] SERVICE REQ.

A controller error has been detected.

[E] SERVICE REQ.

A print engine error has been detected.

XX = 03 Fusing Unit (low temp)

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of

text and graphics.

[S] STANDBY MODE

Cxxx

EOOXX

may

Data still remains in the printer's buffer.

The right column of the

have

removed

you

font