Cisco UCS B420 M3 설치 및 서비스 참고 사항 - 페이지 4
{카테고리_이름} Cisco UCS B420 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B420 M3 38 페이지. High performance blade server
Cisco UCS B420 M3에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (8 페이지)
페이지 인쇄
LED
Activity
(Disk Drive)
Health
(Disk Drive)
Buttons
The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper clip or a similar item.
Hold the button down for five seconds, and then release it to restart the server if other methods of restarting do not work.
The locator function for an individual server may get turned on or off by pressing the locator button/LED.
The power button allows you to manually take a server temporarily out of service but leave it in a state where it can be restarted
quickly. If the desired power state for a service profile associated with a blade server is set to "off," using the power button or Cisco
UCS Manager to reset the server will cause the desired power state of the server to become out of sync with the actual power state
and the server may unexpectedly shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server
action in Cisco UCS Manager.
Local Console Connector
The local console connector allows a direct connection to a blade server to allow operating system installation and other management
tasks to be done directly rather than remotely. The port uses the KVM dongle cable that provides a connection into a Cisco UCS
blade server; it has a DB9 serial connector, a VGA connector for a monitor, and dual USB ports for a keyboard and mouse. With this
4
Color
Description
Off
Inactive.
Green
Outstanding I/O to disk drive.
Flashing Amber
Rebuild in progress. Health LED will flash in unison.
4 Hz
Flashing Amber
Identify drive active.
4 hz
Off
Can mean either no fault detected or the drive is not installed.
Flashing Amber
Rebuild drive active. If the Activity LED is also flashing amber, a
4 hz
drive rebuild is in progress.
Amber
Fault detected.