Cisco UCS B460 M4 설치 및 서비스 참고 사항 - 페이지 20

{카테고리_이름} Cisco UCS B460 M4에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B460 M4 50 페이지. Blade server
Cisco UCS B460 M4에 대해서도 마찬가지입니다: 데이터시트 (7 페이지), 설치 및 서비스 참고 사항 (46 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (5 페이지)

페이지 인쇄

Removing a Blade Server from the Chassis

Step 3

(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis

to completely power off the servers.

Step 4

Remove the appropriate servers from the chassis.

Removing a Blade Server from the Chassis

You must power off the blade server or decommission it using Cisco UCS Manager before physically removing

the blade server from the chassis.

Procedure

Step 1

Turn off the blade server using either Cisco UCS Manager or the power button.

Step 2

If you are removing a UCS B460 M4 blade server, completely loosen the captive screws on the UCS Scalability

Connector and remove the connector by pulling it away from the two UCS B260 blade modules. If you are

removing a UCS B260 M4 blade server, you do not need to remove the UCS Scalability Terminator prior to

removing the UCS B260 M4 blade server.

Step 3

Completely loosen the captive screws on the front of the blade.

Step 4

Remove the blade from the chassis by pulling the ejector levers on the blade until it unseats the blade server.

Step 5

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its

weight.

Step 6

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling

it.

Step 7

If the blade server slot is to remain empty, reinstall the slot divider and install two blade server blanking

panels.

Server Troubleshooting

For general troubleshooting information, see the

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

Cisco UCS Manager Troubleshooting Reference

Installing a Blade Server

Guide.