Cisco UCS C Series 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco UCS C Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS C Series 19 페이지. Security manager 4.3
Cisco UCS C Series에 대해서도 마찬가지입니다: 문제 해결 팁 (11 페이지), 업그레이드 매뉴얼 (11 페이지), 업그레이드 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (12 페이지), 설정 (10 페이지)

페이지 인쇄

Reversing the Cable Management Arm (Optional)

Step 5

Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.

Reversing the Cable Management Arm (Optional)

Step 1

Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.

Step 2

Flip the tabs at the ends of the CMA arms so that they point toward the rear of the server.

Step 3

Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab

and pivot the tab 180 degrees so that it points toward the rear of the server.

Figure 6: Reversing the CMA

CMA tab on end of width-adjustment slider

Initial Server Setup

Note

This section describes how to power on the server, assign an IP address, and connect to server management

when using the server in standalone mode. To use the server in Cisco UCS Manager integration, specific

cabling and settings are required. See

Installing the Server

Metal button on outside of tab

Installation For Cisco UCS Manager

Installing the Server

Integration.